How To Install Night Owl Wireless Camera

Quick Setup Guide

Stop: This photographic camera is NOT for standalone use and MUST be paired to the Night Owl WNIP2 Serial Wi-Fi NVR. Only install a camera in its final location After it'due south paired, and the setup is completed.

Hardware Setup

Install the batteries. Press the push button on the camera's abdomen to release the bombardment cartridge and insert the batteries. Replace the cartridge and connect the USB cable to the port under the rubber piece.
Annotation: Each camera requires 2 rechargeable batteries, but can hold up to 4 batteries.
Charge the camera(due south) for at least three hours. Lift the safety piece on the camera's abdomen and connect the USB cable to the camera and a USB ability supply. Please ensure the batteries are installed or the photographic camera(s) will not charge.
Scan the OR Code to watch the Setup Video on how to pair your photographic camera(s) to the Nighttime Owl WNIP2 Series Wi-Fi ns, N, NVR (Wi-Fi NVR required for apply).

https://scnv.io/j86E?qr=ane
Scan to Picket our Setup Video

Wire-Costless Camera

Placing the Camera in Pairing Mode

If the camera is not in pairing fashion, printing the button on the photographic camera'southward belly to release the battery cartridge. Press and hold the reset push button for 10 seconds or until the photographic camera says, "Camera is in Pairing Mode."
Annotation: The camera MUST be reset if it isn't paired to a Recorder inside two minutes.
Status Light

Pairing Mode:	GREEN light flashes rapidly
Failed to Connect:	Solid Ruby light
Charging:	Green light flashes slowly
Fully Charged:	Solid GREEN low-cal

NOTE: For a complete list of Status Lights, see your owner'south manual past visiting our support site and typing BWNIP2 into the search bar.

Demand Assist?

Why Call? Our Back up Site Has information technology All!
For system manuals, troubleshooting guides, FAQs, video tutorials, and more:

Please visit Back up.NightOwISP.com
Enter BWNIP2 into the Search bar. Search Model / Serie% CM

Ezoic

For more Support Videos, go to world wide web.youtube.com/nightowlsp

FCC RADIATION NORM

FCC
This device complies with Part fifteen of the FCC Rules. Performance is subject to the following two weather condition: (1) this device may non cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired functioning. FCC Compliance Statement These limits are designed to provide reasonable protection against frequency interference in a residential installation. This equipment generates, uses, and tin radiate radio frequency energy, and if non installed or used in accord with the instructions, may cause harmful interference to radio communication. Nonetheless, there is no guarantee that interference volition not occur in television reception, which can exist adamant past turning the equipment off and on. The user is encouraged to endeavour and right the interference by ane or more of the post-obit measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Caution!
The Federal Communications Committee warns the user that changes or modifications to the unit not expressly approved by the party responsible for compliance could void the user's authorisation to operate the equipment. This equipment should be installed and operated with a minimum distance of 8 inches between the radiator and your body. REV one-200803